up to DN 500
SDR 17/ 11
PE 100 Transition piece PE/steel, with long PE coated St37 steel welding end, PE-side long for electrofusion welding, DVGW-tested (up to DN 200) Reg.-Nr. DV-7521BQ0469

Advantages:
High security and durability due to extreme sturdy construction, corrosion protection

up to DN 200
SDR 17/ 11
PE 100 Transition piece PE/ cast iron, pull resistant, PE-side long for electrofusion welding, body of socket with external stainless steel reinforcement, with screw-, clamping-, slide- and sealing ring and with Tyton. DVGW tested

Advantages:
short design, sturdy construction, pull resistant, weldable

DN 80 - DN 150
SDR 17/ 11
Repair coupler PE/PVC, PVC-end with corondum ring, PE-end with Grip-Ring made of POM, EPDM lip seal type 3S and stainless steel bolts, at the front side for safe pre-stressing, additionally cross-slotted screws

Advantages:
Push fit coupler, resistant to longitudinal forces

up to DN 400
SDR 17/ 11
PE 100 transition couplers with pulling-out protection made of ductile cast iron and stainless steel screws A-4, long for electrofusion welding, PVC-pipe to be plugged in, PE-push fit socket with lip seal type 3 S

Advantages:
weldable, resistant to longitudinal forces

up to d 315 mm
SDR 17/ 11
PE 100 and PP

Transition piece, one end with push-fit socket (reinforced) for stoneware spigot end, type 1:

- DN 150 and DN 200 with fixed standard stoneware lip seal gasket, centric ring ensuring an uniform load on the socket sea

- DN 100 and DN 250 – DN 350 with lip seal gasket according to DIN 4034-1

to be plugged onto the stoneware pipe, long for electrofusion welding, no misalignment is possible in the connection piece

Advantages:
weldable, without misalignment, DN 150 and DN 200 with centring ring, easy installation